10/100 Mbps Ethernet), as those standards only use two pairs at all, so the crossover simply swaps the 'transmit' and 'receive' pairs leaving the other (unused) pairs untouched. That is "crossover" in 10BASE-T and 100BASE-TX only (i.e. Note that T568A⇆T568B only swaps two pairs.
Your understanding is 'correct' for 10/100 Mbps links, while the cables you're looking at are 'correct' for 1 Gbps links. When I look at crossover cables, this is not correct Assuming (1) above is correct, then I don't see how this can be correct.īoth kinds of crossover are correct, but for different Ethernet standards. When I look at pinout diagrams showing T568A and T568B, the odd number pins are all color/white with the even number pins solid color. I had always understood (and the Internet has it spewed in multiple places) that if I connect T568A on one side, and T568B on the other I am creating a crossover connection. I hypothesize maybe there is some differential signalling going on to allow it to work, and the pair orders don't make a difference, but that does not feel right?Ĭan anyone confirm that the LED colors are standard across most switches, and that an Orange only light (ie green not on) means there is a problem at the hardware (probably cabling) level? Assuming (1) above is correct, then I don't see how this can be correct. When I look at crossover cables, this is not correct, which makes sense to me.
I further understand that if plugging into a gigabit switch this will still work because it does crossover correction. I strongly suspect that this is indicative of a problem - so questions. I have attempted to terminate my side as both T568A and T568B with the same result each time on the switch - An Orange light on the left side, nothing on the right. I'm trying to wire up an ethernet cable and I suspect the remote end is improperly terminated, but for various reasons I can only access one end, meaning I can't use a cable tester.
0 kommentar(er)
